Project 3D Design

Easy using TinkerCAD when I'm not used to create my own 3D-designs.
http://www.tinkercad.com

It's working..

Then it goes into Prusa slicer

And finally into the printer..

Antenna Inspection today..

Mosley Mini antenna check.. 

Doing some sat mode

FUNcube-1 Dashbord receive today.
Icom IC-9100 via USB.

QRV from Lofoten Remote from Molde

Remote Rig

EU-076 Lofoten

End fed antenna, very bad...

The antenna is seen in the picture. Low over ground, Short and almost no counterpoise...





Nice WX in Molde, Romsdalen..

Good shit today.. :-)

Good 6-meter conds this week

Portable QO-100 setup

While I wait for the 20W Amp...

40cm dish. Modified Starcom SR-3602ACE twin LNB

I found this LNB to be the most sensitive and great for the purpose.

Works great.

100nF capacitor without removing the 25MHz crystal.

Then I feed stabilized frequency from mini Leo Bodnar.


POTY Patch Of The Year...


200mAh on receive for the SG-Labs transverter


1.03 Ah on TX


1W from FT-817nd. Probably to be adjusted down when PA is added. 

2 green led’s on the transverter is good! 😊

432.045 - 432.295 gives 2400.50 - 2400.300

432.190 in is roughly 10.489689GHz down